IKEA IVÖSJÖN cabinet with doors assembly instructions
How to assemble the IKEA IVÖSJÖN cabinet with doors, step by step: 23 animated steps built from the official manual, about 30–45 minutes for 1 person, with pencil, tape measure, wall screws for your wall type (not included).
Green plastic IVÖSJÖN bathroom cabinet: three stacked cubes that click together without tools, each closed by a top-hinged flap door, fixed to the wall with two brackets. Size: 33×34×99 cm (13×13 3/8×39"). About 30–45 minutes, 1 person. Tools: Pencil, Tape measure, Wall screws for your wall type (not included).
Based on the official IKEA manual AA-2738421-1 (PDF). Guide updated .
| Steps | 23 |
|---|---|
| Time | 30–45 minutes |
| People | 1 |
| Tools | Pencil, Tape measure, Wall screws for your wall type (not included) |
| Size | 33×34×99 cm (13×13 3/8×39") |
| Official manual | AA-2738421-1 |
| IKEA article number | 305.690.95 (green) |
| Pieces in the box | 38 |
In the box
| Part | Part number | Quantity |
|---|---|---|
| Base plate A | 1 | |
| Middle plate B | 2 | |
| Top plate C | 1 | |
| Corner post | 12 | |
| Side / back panel | 9 | |
| Door | 3 | |
| Foot | 4 | |
| Top cap | 4 | |
| Wall bracket | 2 |
Steps
- Feet into the base plate — Find plate A (the base, marked A). Hold it up and push the 4 feet up into the sockets at its corners until they sit firmly.
- Four posts on the base — Push a corner post down into each corner of plate A until it clicks. Press the tab at the bottom of the post to check it is locked.
- Hook in the panels — Take 3 panels, circle facing out. Lean each one out a little and click its lower edge into the groove of plate A: left side, back, then right side. Each edge clicks in 3 places.
- Push the panels upright — Push each panel upright so its side edges snap into the grooves of the two posts next to it, 3 clicks on each edge.
- Doors onto the plates B — Lay both plates B upside down. Hook a door onto the hinge pin at one end of the plate edge, then swing its other end down until the second pin clicks in. Do the same with the second plate.
- Fold the doors up — Turn each plate B over so the door hangs down. Swing the door up under the plate and push its handle into the clip so it stays folded flat. Put the second plate aside.
- First plate B on top — Lower one plate B, folded door underneath and front edge to the front, onto the 4 posts. Press down on each corner until it clicks.
- Four posts on plate B — Push 4 more corner posts down into the corners of plate B until they click, as before.
- Panels of the second cube — Fit 3 more panels, circle facing out, as before: click the lower edge into plate B, then push the panel upright until both side edges snap into the posts.
- Second plate B on top — Lower the second plate B, folded door underneath and front edge to the front, onto the posts and press each corner down until it clicks.
- The last four posts — Push the last 4 corner posts down into the corners of the upper plate B until they click.
- Panels of the top cube — Fit the last 3 panels the same way: lower edge into the plate, then push each panel upright into the posts.
- Door onto plate C — Hook the last door onto top plate C the same way as on the plates B. Turn the plate over, swing the door up under it and push the handle into the clip.
- Top plate C on — Lower plate C onto the posts, folded door underneath and the side with the two slots to the back. Press down until all 8 catches click.
- Caps on the posts — Press a cap into each corner of plate C, onto the post tops, until it clicks.
- Open out the doors — Pull each door forward out of its clip and let it swing down until it hangs closed in front of its cube.
- Wall brackets into the top — Turn the cabinet round. Slide the 2 wall brackets up into the slots in the back edge of plate C, then turn the cabinet back.
- Mark the wall — Stand the cabinet where it will go, back against the wall. Mark the top of each bracket on the wall with a pencil. Check: Furniture can tip over. This cabinet must be fixed to the wall.
- Move the cabinet, take off the brackets — Move the cabinet away from the wall. Slide the 2 brackets down out of the slots in plate C.
- Mark the screw holes — Hold each bracket against the wall with its top on your pencil mark; the holes are 175 mm apart. Mark the wall through the screw hole, then take the bracket away.
- Screw the brackets to the wall — Hold each bracket on its marks and screw it to the wall. Screws are not included: choose ones that suit your wall, with a flat (pan) head, not a countersunk head. Check: If you are unsure which screws or plugs suit your wall, ask a specialist.
- Hang the cabinet on the brackets — Lift the cabinet slightly, push it back against the wall and lower it so the slots in plate C drop down over the two brackets.
- Done! — Your IVÖSJÖN cabinet is finished and fixed to the wall. Lift each door by its finger scoop to open it.
IVÖSJÖN cabinet with doors: questions and answers
How long does it take to assemble the IKEA IVÖSJÖN cabinet with doors?
About 30–45 minutes for 1 person, working through the 23 steps of this guide. Unpack and sort the hardware first: the In the box list has every part with its count, so you can check nothing is missing before you start.
What tools do I need for the IVÖSJÖN cabinet with doors?
Pencil, tape measure, wall screws for your wall type (not included).
Can one person assemble the IVÖSJÖN cabinet with doors?
Yes, it is a one-person build.
Does the IVÖSJÖN cabinet with doors need to be fixed to the wall?
The manual shows a wall fixing: see step 17 (Wall brackets into the top) and step 18 (Mark the wall). Use screws and plugs that suit your wall (wood, brick, concrete or plasterboard), and ask at a hardware store if you are not sure. Tall furniture and drawer units that are not fixed to the wall can tip over.
What size is the IVÖSJÖN cabinet with doors once assembled?
33×34×99 cm (13×13 3/8×39"), as given for this model. Leave extra floor space around it while you build.
Where can I download the IKEA IVÖSJÖN cabinet with doors assembly instructions PDF?
The official PDF is manual AA-2738421-1, free from ikea.com; this guide links it next to the steps. To find the product page with its documents, search ikea.com for article number 305.690.95 (green); other colours have their own numbers but usually the same manual.
Which IKEA manual is this guide based on?
The official manual AA-2738421-1. Manuals and fittings change over time, so compare this code with the one printed on your paper manual. If they differ, follow your paper manual.
Related assembly guides
- IKEA BILLY bookcase assembly instructions
- IKEA KALLAX shelf unit 2x4 assembly instructions
- IKEA BESTÅ frame assembly instructions
- IKEA HYLLIS shelving unit (in/outdoor) assembly instructions
- IKEA LACK wall shelf assembly instructions
- IKEA VESKEN shelf unit assembly instructions
- IKEA EKET cabinet assembly instructions
- IKEA BRIMNES bookcase assembly instructions
All bookcases & shelves assembly guides · All furniture assembly guides
Stuck on a step? Common assembly problems and fixes · Furniture hardware explained