IKEA OMAR shelving unit (galvanised) assembly instructions
How to assemble the IKEA OMAR shelving unit (galvanised), step by step: 11 animated steps built from the official manual, about 20–30 min for 1 person, with screwdriver + wall screws and plugs (not included) for the wall fixing.
Galvanised steel wire shelving: three wire shelves slide onto four posts and wedge onto plastic clips, then the unit is clipped to the wall. Size: 92×36×94 cm (36 1/4×14 1/8×37"). About 20–30 min, 1 person. Tools: No tools for the unit, Screwdriver + wall screws and plugs (not included) for the wall fixing.
Based on the official IKEA manual AA-108683-16 (PDF). Guide updated .
| Steps | 11 |
|---|---|
| Time | 20–30 min |
| People | 1 |
| Tools | No tools for the unit, Screwdriver + wall screws and plugs (not included) for the wall fixing |
| Size | 92×36×94 cm (36 1/4×14 1/8×37") |
| Official manual | AA-108683-16 |
| IKEA article number | 100.697.63 |
| Pieces in the box | 43 |
In the box
| Part | Part number | Quantity |
|---|---|---|
| Post | 4 | |
| Wire shelf | 3 | |
| Levelling foot | 139294 | 4 |
| Clip half | 130531 | 24 |
| Cap | 139285 | 4 |
| Wall bracket | 10054272 | 2 |
| Spacer | 10054270 | 2 |
Steps
- Feet into the posts — Lay the 4 posts side by side on the floor. Screw a levelling foot (139294) clockwise into the same end of each post until it is snug. Check: Work on a rug or the cardboard from the box so the floor does not get scratched.
- Clips for the bottom shelf — Near the foot end of each post, snap the two halves of a clip (130531) into the same groove, one from each side, so they close round the post. 8 halves in total. Check: Both halves must sit in the same groove, with the narrow end of the clip pointing away from the foot. Halves in different grooves will not hold the shelf.
- First shelf onto two posts — Stand the first wire shelf on its long edge at the clip end of the posts. Slide the 2 posts lying underneath it through the 2 lower corner collars, top end first, until the collars sit on the clips. Check: Check the shelf is the right way round: the support wires under the shelf face the feet.
- The other two posts — Lift the other 2 posts level with the upper corner collars and slide them through, top end first, until those collars sit on the clips too.
- Stand it up, clips for the middle shelf — Tip the unit up onto its feet. Then snap a pair of clip halves (130531) into the same groove on each post, about halfway up. 8 halves in total. Check: Count the grooves so all four clips are at the same height, otherwise the shelf will not be level.
- Middle shelf — Lower the second shelf over the tops of the posts, a corner collar onto each post, and push it down evenly until it sits on the clips.
- Clips for the top shelf — Snap a pair of clip halves (130531) into each post a few grooves below its top. 8 halves in total. Check: Both halves in the same groove, narrow end up.
- Top shelf — Lower the third shelf over the tops of the posts and push it down until it sits on the clips, just below the post tops.
- Caps on the posts — Press a cap (139285) into the top of each post.
- Fix it to the wall — Stand the unit against the wall. On each back post, just under the top shelf: push a spacer (10054270) onto the tab of a wall bracket (10054272), clip the bracket onto the post and screw the tab to the wall. Shown for a gap of about 10 mm to the wall; for about 3 mm leave the spacer out, for about 15 mm turn it the other way round. Check: Must be fixed to the wall to prevent tipping. Wall screws and plugs are not included: use ones that suit your wall.
- Done! — Your OMAR shelving unit is assembled and fixed to the wall. Turn the feet to level it on an uneven floor. Max load 33 kg per shelf.
OMAR shelving unit (galvanised): questions and answers
How long does it take to assemble the IKEA OMAR shelving unit (galvanised)?
About 20–30 min for 1 person, working through the 11 steps of this guide. Unpack and sort the hardware first: the In the box list has every part with its count, so you can check nothing is missing before you start.
What tools do I need for the OMAR shelving unit (galvanised)?
Screwdriver + wall screws and plugs (not included) for the wall fixing.
Can one person assemble the OMAR shelving unit (galvanised)?
Yes, it is a one-person build.
Does the OMAR shelving unit (galvanised) need to be fixed to the wall?
The manual shows a wall fixing: see step 10 (Fix it to the wall) and step 11 (Done). Use screws and plugs that suit your wall (wood, brick, concrete or plasterboard), and ask at a hardware store if you are not sure. Tall furniture and drawer units that are not fixed to the wall can tip over.
What size is the OMAR shelving unit (galvanised) once assembled?
92×36×94 cm (36 1/4×14 1/8×37"), as given for this model. Leave extra floor space around it while you build.
How many screws and fittings come with the OMAR shelving unit (galvanised)?
36 fittings of 5 kinds, the most numerous being 24 × clip half, 4 × levelling foot, 4 × cap. The In the box table lists every one with its part number, so you can count them before you start.
Where can I download the IKEA OMAR shelving unit (galvanised) assembly instructions PDF?
The official PDF is manual AA-108683-16, free from ikea.com; this guide links it next to the steps. To find the product page with its documents, search ikea.com for article number 100.697.63; other colours have their own numbers but usually the same manual.
Which IKEA manual is this guide based on?
The official manual AA-108683-16. Manuals and fittings change over time, so compare this code with the one printed on your paper manual. If they differ, follow your paper manual.
What if a part or screw is missing?
Check every box and all the packaging first: small fittings are often taped inside. Each fitting in the In the box list has its IKEA part number (for example levelling foot 139294). IKEA customer service can send replacement fittings using that number.
Related assembly guides
- IKEA BILLY bookcase assembly instructions
- IKEA KALLAX shelf unit 2x4 assembly instructions
- IKEA BESTÅ frame assembly instructions
- IKEA HYLLIS shelving unit (in/outdoor) assembly instructions
- IKEA LACK wall shelf assembly instructions
- IKEA VESKEN shelf unit assembly instructions
- IKEA EKET cabinet assembly instructions
- IKEA BRIMNES bookcase assembly instructions
All bookcases & shelves assembly guides · All furniture assembly guides
Stuck on a step? Common assembly problems and fixes · Furniture hardware explained